Model G8993 4" Tile Saw-6-
Assembly
1. Install appropriate blade (not included)
using the box wrench and end wrench
provided (Figure 2). The blade arbor
retaining bolt has a reverse thread.
2. Attach the water valve to the saw using
the machine screw provided. The plug
should be attached in such a manner
that the watering posts sit on either
side of the blade, and the valve sits
near the back of the handle (Figure
3).
Figure 3. Attach the water plug.
3. Attach the vinyl hose to the water valve
(Figure 4).
Figure 2. Attach the cutting blade.
4. When connecting the tile saw to a
threaded faucet or hose, use the sup-
plied rubber connector. When using a
water tank, the tank should be located
at least 31
1
⁄2" higher than the work area
(Figure 5).
Figure 4. Attach the vinyl hose.
Serious personal injury could occur
if you do not disconnect the saw
from power while installing the blade
or the watering attachment. Always
unplug the saw while performing
either of these actions.
Figure 5. Using a water tank.
31
1
⁄2"