Filter
Top Products
Model G8993 4" Tile Saw -7-
SECTION 4: OPERATIONS
1. Put on safety goggles, hearing protec-
tion, and an approved respirator.
2. Set the saw base on the material to be
cut. Use the side of the base to align
the diamond wheel with the layout line.
3. Make sure the diamond wheel is kept
off the material to be cut, and turn the
switch ON.
4. Move the saw steadily along the layout
line while maintaining a firm grip on the
tool.
5. To adjust the cut depth, unplug the tool,
then loosen the wing bolt on the base
adjustment bracket and move the base
to adjust the depth (Figure 6).
6. After adjusting the cutting depth, fasten
the wing bolt securely.
Figure 6. Adjusting the cutting depth.
Operation
If the diamond wheel stops or makes
an abnormal noise while operating,
promptly switch the saw OFF.
Shortened blade life and personal inju-
ry may result if the diamond wheel
is not used properly. Do not use the
diamond wheel for making curved or
radius cuts.
Always use the correct blade for the
application. When cutting or scribing
concrete, tile, or stone, always use
the water attachment. Never use any
blade other than a diamond blade with
this saw.
If the cutting depth exceeds 20mm, as
with concrete or other materials, the
cut should be made with two passes;
otherwise, blade and motor life may be
shortened.
NOTICE