Filter
Top Products
-10- G9922 Oscillating Spindle Sander
SECTION 5: Operations
Before you put your oscillating spindle sander
into use, give it a quick inspection. Before
inspecting, ensure that the machine is switched
off and disconnected from its power source.
1. Are all fasteners tight?
2. Is the sanding sleeve properly installed and
secured?
3. Rotate the spindle slowly by hand. Look
and listen for any scraping noises or any-
thing that impedes smooth movement.
Make appropriate adjustments before
attempting to run the machine.
4. If the sander appears to be free of prob-
lems that might affect its operation, plug it
in to its power source and start the
machine. Be sure to keep a finger on the
OFF button, just in case of a problem with
the machine. Allow to run briefly to allow
inspection of spindle rotation.
5. Turn off the machine, disconnect it from its
power source, and re-inspect for loose fas-
teners.
Never use the Model G9922 for applications
other than those for which it was made. DO
NOT overload the machine or use excess
force when sanding. Severe personal
injury, damage to the machine, or damage
to your workpiece could occur.
For general wood sanding, position and secure
table, turn the machine on and place workpiece
on table. While securely holding workpiece,
slowly feed against the spindle and maintain con-
stant pressure against the table. Use caution
when sanding end-grain.
Table can be tilted at angles up to 45° to allow
sanding of angled edges. Simply loosen the
knobs located on either side of the table base
and set to desired angle. Always check angle
measurement against an adjustable angle finder.
Test-Run
General Sanding