Filter
Top Products
G9922 Oscillating Spindle Sander -11-
SECTION 6: MAINTENANCE
General
Shielded and pre-lubricated ball bearings require
no lubrication.
The working table and other non-painted sur-
faces on the Model G9922 should be protected
against rust and pitting. Some woodworkers rec-
ommend using automotive paste wax on
exposed steel and cast iron surfaces. If you use
paste wax, make sure that it’s 100% Carnauba
wax and does not contain silicone.
Make a habit of inspecting your sander each time
you use it. Check for the following conditions and
repair or replace when necessary.
1. Loose mounting bolts.
2. Worn switch.
3. Worn or damaged cords and plugs.
4. Loose Sanding Spindle and Sleeve.
Lubrication
Sander Tables
Sanding Sleeves
The spindle accepts 2" x 5
1
⁄2" sanding sleeves.
For spindle sanding, we recommend a 100 grit
(medium) material for general purpose sanding, a
60 grit (coarse) material for rough work, and a
150 grit (fine) material for finish jobs.