Filter
Top Products
G9958 4 H.P. Dust Collector -11-
Align the right and left side bases with the main
base and attach them using (8)
5
⁄16" x
1
⁄2" hex bolts
as shown in Figure 5.
Lay the fan/motor assembly upside down and
attach the four legs using (8)
5
⁄16" x
1
⁄2" hex bolts as
shown in Figure 6.
Turn the fan/motor assembly rightside up and
place it on top of the base assembly. Line up the
mounting holes in the legs with those in the base
and attach using (8)
5
⁄16" x
1
⁄2" hex bolts as shown
in Figure 7.
Figure 5. Assembling the three base sections.
Figure 6. Connect the fan/motor to the legs.
Figure 7. Attach the fan/motor/leg to the base.
Fan/Motor Assembly
Place one of the rubber gaskets on one of the two
intake openings. While holding the gasket in
place, attach one of the collectors to the intake
opening, making sure the gasket is aligned with
the mounting holes. Fasten them together using
(8)
5
⁄16" x 1" hex bolts as shown in Figure 8.
Repeat this procedure for attaching the second
collector to the other intake opening. Make sure
these bolts are fastened tight so they make a
good seal.
Collectors
Figure 8. Attaching the collectors.