Filter
Top Products
G9969 Radial Drill Press
-15-
Components and Hardware Needed: Qty
Base ..................................................................
1
Column ..............................................................
1
Hex Bolts
1
⁄
2
"-13 x 2" ......................................... 4
Flat Washers
1
⁄
2
" ................................................ 4
To install the column on the base:
1. Place the column on the base, making sure
to align the holes in both the column and the
base.
2. Have an assistant hold the column steady-
while you secure the column to the base with
the hex bolts, as shown in
Figure 6.
Column
Figure 6. Assembled column and base.
2. Loosen the cap screw on the column cap and
remove the cap and rack from the column.
Figure
7. Marking the top of the rack.
Components and Hardware Needed: Qty
Headstock Bracket ............................................
1
Column ..............................................................
1
Column Cap ......................................................
1
Lock Handles ...................................................
2
Crank Handle ....................................................
1
Crank Handle Arm .............................................
1
To mount the headstock bracket on the col
-
umn
:
1. Mark the top of the rack, as shown in Figure
7, to reference which end is the top.
Headstock Bracket
Lag Shield Anchor
Typical Anchor Stud
Figure 5. Different floor mounting methods.
Lag Bolt
Machine Mount