Filter
Top Products
-16-
G9969 Radial Drill Press
Figure 9. Headstock bracket lock handles.
Components and Hardware Needed: Qty
Base/Column/Bracket Assembly .......................
1
Headstock .........................................................
1
To install the headstock:
1. With the help of an assistant, lift the head-
stock and slide it onto the bracket column, as
shown in
Figure 10.
Headstock
Figure 10. Mounting the headstock.
2. Align the headstock with the base and tighten
the two set screws shown in
Figure 11.
Figure
8. Mounting headstock bracket.
3. Place the rack inside the headstock bracket,
engage it with the gear inside the headstock
bracket, and with help of assistants, slide the
rack and headstock bracket onto the column,
as shown in
Figure 8.
Figure 11. Headstock set screws.
Set Screws
4. Re-install the cap and tighten the cap screw.
5.
Install the lock handles as shown in Figure 9.
6.
Screw the crank handle into the crank handle
arm.
7.
Loosen the set screw located in the crank
handle arm, and slide the crank handle arm
onto the crank shaft. Tighten the set screw.
Lock
Handles