Filter
Top Products
G9969 Radial Drill Press
-17-
Components and Hardware Needed: Qty
Downfeed Handles ............................................
3
Cover Knob
1
⁄
4
"-20 ............................................. 1
Phillips Head Screw
1
⁄
4
"-20 x
1
⁄
2
" ........................ 1
Flat Washer
1
⁄
4
" .................................................. 1
The downfeed handles must be installed to oper
-
ate the drill press.
To install the downfeed handles:
1. Thread the downfeed handles into the pinion
hub, as shown in Figure 12
.
Downfeed Handles &
Belt Cover Knob
Figure 12. Downfeed handles installed.
Pinion
Hub
Belt Cover
Knob
2. Remove the screw that fastens the belt cover
in place and install the belt cover knob in its
place
.
Components and Hardware Needed: Qty
60W Light Bulb (not included) ............................
1
The Model G9969 includes a light socket, intend
-
ed for 110V usage only. When the drill press is
shipped from the factory, a dust plug is installed
in the light socket for protection.
To install a light bulb in the drill press:
1. Remove the dust plug from the light socket.
2. Install a 60W or smaller light bulb in the loca-
tion shown in
Figure 13.
Light (110V Only)
Figure 13. Light bulb access location.
Light Bulb
Access Here
The light socket includ-
ed with this drill press
is for 110V USE ONLY.
If the light socket is
used while operating
at 220V, the light bulb
WILL EXPLODE, poten-
tially causing serious
personal injury.