Filter
Top Products
H0603 18V Cordless Drill and Saw-6-
DRILL OPERATIONS, CON’T
2. Hold the chuck by the collar while
turning the sleeve (the forward sec-
tion). See Figure 1. This will cause
the three chuck jaws located inside
the recess to open or close depend-
ing upon the direction.
3. When the jaws are at the approximate
diameter of the bit or driver, insert the
shank end of the bit or driver into the
jaw opening.
4. Turn the sleeve clockwise until it tight-
ens around the bit or driver. Never
“power tighten” which is holding the
sleeve while running the drill. This
can cause a loose grip on the bit or
driver and potential damage to chuck
jaws. Check for tightness periodically
while using the tool.
5. To release the bit or driver, hold the
chuck collar, and turn the sleeve
counterclockwise.
Fig 1. Inserting bits into the chuck.
Operating this equipment has the
potential for flying debris to cause eye
injury. Always wear safety glasses or
goggles when operating equipment.
Everyday glasses or reading glasses
only have impact resistant lenses, they
are not safety glasses. Be certain the
safety glasses you wear meet the
appropriate standards of the American
National Standards Institute (ANSI).
Like all power tools, there is danger
associated with the Model H0603.
Accidents are frequently caused by
lack of familiarity or failure to pay
attention. Use this tool with respect
and caution to lessen the possibility of
operator injury. If normal safety pre-
cautions are overlooked or ignored,
serious personal injury may occur.