Filter
Top Products
-14-
H8126 Wide Wheel Ginder
Test Run
When your machine is mounted and assembly is
complete, test run your machine to make sure it
runs properly.
If, during the test run, you cannot easily locate
the source of an unusual noise or vibration,
stop using the machine immediately, review the
Troubleshooting on Page 22, and correct the
problem.
If you cannot remedy a problem, contact our Tech
Support at (570) 546-9663 for assistance.
To test run the machine:
1. Make sure you have read the safety instruc-
tions at the beginning of the manual and that
the grinder is is setup properly.
2. Make sure the switch is in the OFF position.
3. Connect the grinder to the power source.
4. Make sure all tools and objects used during
set up are cleared away from the grinder.
5. Turn the grinder ON. Keep your hand poised
over the switch in case you need to quickly
turn the machine
OFF.
6. Listen to and watch for abnormal noises.
Under normal conditions, the grinder will hum
or vibrate little.
—Investigate the cause of unusual noises
and eliminate them before operating the
machine further. Always disconnect the
machine from power before investigating
or correcting potential problems.
7. Turn the grinder OFF.
Figure 10. Left tool rest and eye shield
assembly.
2. Assemble the right tool rest and eye shield in
the same manner.
Phillips Head
Screws 8-32 x
3
⁄8
Hex Bolt
5
/16-18 x
3
⁄8
Hex Bolt
1
/4-20 x
3
⁄8