Filter
Top Products
Model H8235 3-Piece Framing/Brad/Palm Nailer Kit
-9-
OPERATIONS
Loading
When replacing nails in your Model H8235
framing and brad nailers follow these
guidelines:
Framing Nailer
Nail Size ......................
1
⁄8" Shank Diameter
Nail Strip Angle .................21º Round Head
Length..............................................2"–3
1
⁄2"
Magazine Capacity ........................60 Nails
To load your framing nailer:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Grip the nailer firmly and point the nose
down, then pull the magazine pusher
back until the catch lever engages, as
shown in Figure 3.
3. Insert a strip or two of nails, pointed-
end down, into the magazine as shown
in Figure 4.
4. Tilt the nailer to slide the nails all the
way down to the nose.
5. With one hand on the magazine pusher
for control, release the magazine catch
and slowly allow the pusher to press
against the nails.
Brad Nailer
Nail Size ..................................... 18 Gauge
Nail Length ........................................
5
⁄8"–2"
Magazine Capacity ......................100 Nails
To load your brad nailer:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Press the magazine latch toward
the front of the nailer, as shown in
Figure 5.
Figure 4. Loading nails into the magazine.
Figure 3. Sliding magazine pusher back
and engaging catch lever.
Pusher
Figure 5. Pressing the magazine latch.