Filter
Top Products
Model H8235 3-Piece Framing/Brad/Palm Nailer Kit
-12-
A jammed nail must be cleared before
using the nailer again.
Framing Nailer
To clear a jammed nail from the dis-
charge area:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Pull back and latch the magazine push-
er.
3. Remove the nail stick from the maga-
zine.
4. Locate the opening in the underside of
the nailer safety nose (see Figure 9).
Clearing Jammed
Nails
5. Dislodge the jammed nail with a tool
that will fit in the slot on the underside
of the nose.
6. Throw the damaged nail away and
insert a new nail stick that only contains
clean, undamaged nails. DO NOT use
dirty or damaged nails!
7. Release the catch lever and slowly
let the pusher slide to the front of the
magazine.
Figure 9. Nose opening for clearing a
jammed nail.
Nose Opening
Brad Nailer
To clear a jammed nail from the dis-
charge area:
1. DISCONNECT NAILER FROM THE
AIR SUPPLY!
2. Depress the magazine latch and pull
the magazine cover back until it stops.
3. Remove the nail stick from the maga-
zine.
4. Remove the two cap screws and driver
guide cover from the nose assembly
(see Figure 10).
Figure 10. Removing guide cover.
5. The jammed nail should now be visible;
remove it with needle nose pliers.
6. Re-install the guide cover with the two
cap screws removed in Step 4.
7. Throw the damaged nail away and
insert a new nail stick that only contains
clean, undamaged nails. DO NOT use
dirty or damaged nails!
8. Push the magazine cover all the way
forward until the magazine latch locks
it in place.