Filter
Top Products
Model G0765 (Mfd. Since 12/13)
-21-
Te st Ru n
Once assembly is complete, test run the machine
to ensure it is properly connected to power and
safety components function properly.
If you find an unusual problem during the test run,
immediately stop the machine, disconnect it from
power, and fix the problem BEFORE operating the
machine again. The
Troubleshooting
table in the
SERVICE section of this manual can help.
DO NOT start machine until all preceding
setup instructions have been performed.
Operating an improperly setup machine
may result in malfunction or unexpect-
ed results that can lead to serious injury,
death, or machine/property damage.
Serious injury or death can result from
using this machine BEFORE understanding
its controls and related safety information.
DO NOT operate, or allow others to operate,
machine until the information is understood.
To test run machine:
1. Set spindle direction switch to neutral ("0"
position), and turn variable speed dial all the
way counterclockwise to "0".
High/Low
Range Lever
Feed Direction Lever
DOWN (CCW Rotation)
UP (Clockwise Rotation)
CENTER (Neutral)
HIGH
LOW
Figure 16. Lever settings.
2. Shift high/low range lever on back of lathe to
LOW, and feed direction lever to neutral (see
Figure 16).
Figure 15. Headstock controls.
Spindle Direction
Switch Set to "0"
3. Make sure chuck and jaws, if installed, are
secure (see Chuck Installation on Page 26).
Note: If a chuck is not installed on the lathe,
you do not need to install one for this test run.
Emergency
Stop Button
Feed
Direction
Lever
High/Low
Range Lever
Variable Speed Dial
Set to "0"