Filter
Top Products
-36-
Model G0765 (Mfd. Since 12/13)
Steady Rest
Tools Needed for Installation/Removal Qty
Open-End Wrench 14mm .................................. 1
Open-End Wrench 16mm .................................. 1
The steady rest supports long shafts and can be
mounted anywhere along the length of the bed-
way
.
Familiarize yourself with the steady rest com-
ponents shown below
to better understand the
controls.
To install and use the steady rest:
1. DISCONNECT LATHE FROM POWER!
2. Thoroughly clean all mating surfaces, then
place steady rest base on bedways.
3. Loosen finger lock nuts (see Figure 40), turn
finger adjustment knobs, and adjust fingers
as required for workpiece.
4. Loosen steady rest lock nut, position steady
rest where required to properly support
workpiece, then secure lock nut.
5. Turn finger adjustment knobs so fingers
barely touch workpiece, then tighten finger
lock nuts.
6. Lubricate finger tips with an anti-seize lubri-
cant during operation. Note: Mill or file tips if
they show wear.
Figure 40. Steady rest components.
Lock
Nut
Finger
Lock Nut
Finger
Finger
Adjustment
Knob