Filter
Top Products
-26-
Model G0765 (Mfd. Since 12/13)
Chuck Installation
4. Insert chuck screws through mounting holes
in spindle backplate, as shown in Figure 20.
Make sure chuck seats firmly and evenly
against backplate shoulder.
5. Use a lock washer and hex nut on each
chuck screw to secure chuck (see Figure
21).
Figure 20. Inserting chuck into backplate.
To ensure accurate work, it is extremely important
to make sure the spindle nose and chuck mating
surfaces are clean. Even a small amount of lint or
debris can affect accuracy.
The chuck is properly installed when it is seated
against the backplate shoulder (see Figure 19
below).
To install the chuck:
1. DISCONNECT LATHE FROM POWER!
2. Use an appropriate device to protect ways dur-
ing installation process (refer to Installation
& Removal Device on Page 25).
3. Thoroughly clean and wipe-down all mating
surfaces with a lightly-oiled, lint-free rag.
Tools Needed: Qty
Open-End Wrench 10mm .................................. 1
Figure 19. Spindle backplate.
Inside
Taper
Mounting
Hole
Backplate
Shoulder
Figure 21. Chuck secured against backplate.
Hex Nut
Lock Washer
Intrinsic
Backplate
Chuck Screw