Filter
Top Products
-8-
Model T10432 (Mfg. Since 11/10)
Inventory
Inventory (Figure 1) Qty
A. Router Mounting Board 3
7
⁄8" ID .................. 1
— Insert 2
5
⁄8" ID .......................................... 1
— Insert 1
1
⁄4" ID ........................................... 1
B. Fence Support ............................................ 1
C. Fence Boards ............................................. 2
D. Guard ......................................................... 1
E. Table ........................................................... 1
F. Fence Scale Tapes ..................................... 2
G. Rubber Feet ............................................... 4
H. Long Bottom Stand Braces 27
1
⁄4" ............... 2
I. Long Top Stand Braces 22
1
⁄4" .................... 2
J. Short Bottom Stand Braces 19
3
⁄4" .............. 2
K. Short Top Stand Braces 14
1
⁄2" ................... 2
L. Dust Port Housing ...................................... 1
M. Stand Legs 33" ........................................... 4
N. Dust Port 2
1
⁄2"............................................. 1
The following is a list of items shipped with your
machine. Before beginning setup, lay these items
out and inventory them.
If any non-proprietary parts are missing (e.g. a
nut or a washer), we will gladly replace them; or
for the sake of expediency, replacements can be
obtained at your local hardware store.
NOTICE
If you cannot find an item on this list, care-
fully check around/inside the machine and
packaging materials. Often, these items get
lost in packaging materials while unpack-
ing or they are pre-installed at the factory.
O. Hardware (Not Shown):
— Hex Bolts M6-1 x 16 (Table/Braces) ....... 4
— Fender Washers 6mm (Table/Braces) .... 4
— Carriage Bolts M8-1.25 x 12 (Stand) .... 32
— Flat Washers 8mm (Stand) ................... 32
— Hex Nuts M8-1.25 (Stand) .................... 32
— Hex Bolts M8-1.25 x 25 (Fence) ............. 6
— Flat Washers 8mm (Fence) .................... 6
— Star Knobs M8-1.25 (Fence) ................... 6
— T-Bolts M6-1 x 25 (Guard) ...................... 2
— Flat Washers 6mm (Guard) .................... 2
— Tri-Knobs M6-1 (Guard) .......................... 2
— Phillips Head Screws M5-.8 x 55 ............ 2
—Starting Pin ............................................. 1
— Hex Wrench 3mm ................................... 1
Figure 1. Model T10432 inventory.
A
B
C
D
E
F
G
H
I
J
K
L
M
N