Filter
Top Products
Model T10432 (Mfg. Since 11/10)
-9-
Assembly
To assemble the router table:
1. Turn the table upside down on a protective
surface, then attach the (2) long top stand
braces to the table with (4) M6-1 x 16 hex
bolts and 6mm fender washers, as shown in
Figure 2.
2. Attach each stand leg to a long and short top
brace with (16) M8-1.25 x 12 carriage bolts,
8mm flat washers, and M8-1.25 hex nuts, as
shown in Figure 3.
Note: For now, hand-tighten the stand fasten-
ers. In a later step, the stand will be squared
up and the fasteners fully tightened.
Figure 2. Long top stand braces attached to the
underside of the table.
3. Attach the long bottom stand braces to the
legs with (8) M8-1.25 x 12 carriage bolts,
8mm flat washers, and M8-1.25 hex nuts, as
shown in Figure 4.
4. Attach the short bottom stand braces with the
remaining (8) M8-1.25 x 12 carriage bolts,
8mm flat washers, and M8-1.25 hex nuts, as
shown in Figure 5.
5. Install the (4) rubber feet onto the ends of the
legs. Turn the stand and table assembly over,
square up the stand, then fully tighten all the
fasteners.
x 4
Long Top
Stand Braces
Figure 3. Stand legs and short top stand braces
attached.
x 16
Leg
Short Top
Stand Brace
Figure 4. Long bottom stand braces attached.
x 8
Long Bottom
Stand Brace
Figure 5. Short bottom stand braces attached to
the legs.
x 8
Short Bottom
Stand Braces