GTO GTO Stud Sensor User Manual


  Open as PDF
of 9
 
Wireless Exit Sensor
3
Receiver
Transmitter
Module
Driveway
10 -12 inch deep pit
15 ft
maximum
Vehicle Sensor
100 ft
Maximum
Install the Vehicle Sensor
DO NOT fill the hole until final testing is complete.
•Digasmallpitabout10-12inchesdeepclosetotheedgeofyourdriveway.Theholeshouldallowyoutolay
theVehicleSensoratinthebottomwiththelengthoftheVehicleSensorparalleltothedirectionofthedriveway.
•NOTE:ForGTOReceiver#AQ201-NB(Grey
inColor)R4500WirelessWandis“plugand
play”andwillwork.ForGTOReceiver#A2Q201
(Black)andallothermodelreceivers,enclosed
RB709U-NBisrequired.
•Afterlayingthevehiclesensorintheholeadjacent
tothedriveway.Runthesignalcabletothe
 transmittermoduleinthenarrowtrench.
Do not fill the hole or trench until satisfactory
operation is verified.
Vehicle Sensor
10-12 inch
deep pit
Placed 2 ft maximum
from edge of driveway
Vehicle Sensor should
lay parallel to driveway
D R I V E WAY
Transmitter Module Placement
Determining Transmitter Module Location
•Choosealocationforthetransmittermodulethatisfarenoughfromthedrivewayedgethatvehiclesare
unlikelytohitit.Fifteenfeetofwireisincludedtoallowthetransmittertobe12to15feetfromthedriveway.
Totestthechosenlocationtobesureitisfreefromobstructionsorotherinterference,youcanuseyour
remotecontroltransmitteratthesameheightasthetransmittermoduletoactivatethegate.
 previous next