GTO GTO Stud Sensor User Manual


  Open as PDF
of 9
 
Wireless Exit Sensor
5
GTO WIRELESS EXIT WAND
TRANSMITTER
CODE
MED
TRANSMIT
ACTIVE
MIN MAX
SENSITIVITY
NOTE: The module should extend out
at least 12” above ground.
• InstallandconnecttheRB709U-NBreceivertoyourgateoperatorasshownintheinstructionssuppliedwith
thatreceiver.YoucanskipthisstepifyouhaveaGTOGEN3controlboardonyourgateoperator.
• IfusingtheRB709U-NBreceiver,itisrecommendedthatyoudisconnecttheoriginalantennareceiverthat
camewithyourgateopener.
• RemovetheoutercoverfromtheElectronics/TransmitterModule.
• SetthetransmitterDipSwitches.IfyouhaveGTOhandheldtransmittersforyourgate,settheDipSwitchesin
 theTransmitter/ModuletothesamesettingsastheDipSwitchesinyourtransmitter.IfyoudonothaveGTO
 transmitters,settheDipSwitchestoanydesiredsetting.Wedonotrecommendusingthefactorycode
settingasshipped.
• Setthesensitivitycontroltomidscale(mediumsensitivity).
• DONOTinstallthebatteriesatthistime!
GTO WIRELESS EXIT WAND
TRANSMITTER
CODE
MED
TRANSMIT
ACTIVE
MIN MAX
SENSITIVITY
Sensitivity
Potentiometer
Dip Switches
Transmit Indicator
• SecuretheElectronics/TransmitterModuleon
thesuppliedPVCpipebyburyingthebottomthird
 ofthepipeinthesoilandtampingtheground
aroundthepipe.DONOTcovertheelectronics
modulewithametalcoverasthiswillcause
signalinterference.
• Thiscompletesthehardwareinstallation.
Electronics/Transmitter Module Setup
Planting the Electronics/Transmitter Module
 previous next