Filter
Top Products
ASSEMBLY
Step 1: Thread the HANDLE (#47) into the side of the Angle Grinder as shown in Figure 1.
Tighten.
Angle Grinder Assembly
Handle (#47)
Figure 1 — Handle Assembly
Step 2: Remove the FLANGE NUT (#46) from the ARBOR (#4).
Page #4 -- SKU: 30304
Warning:
There are certain applications for which this tool was designed. Harbor Freight Tools
strongly recommends that this tool not be modified and/or used for any application other
than which it was designed.
All accessories must be rated for at least the RPM speed recommended on the
tool’s warning label. Wheels and other accessories running over rated speed can fly
apart and cause injury.
For safest operation, it is recommended that only these accessories be used with this
product:
Abrasive Cut-Off Discs and Wheels Flap Wheels
Wire Brushes Wire Wheel Brushes
Always use an approved and proper guard when using the above mentioned acces-
sories. Each accessory must have the correct arbor size and must fit properly on
the shoulder bushing. Make sure accessories are tightened down securely.
CAUTION: NEVER INSTALL A CARBIDE TIPPED OR STEEL CIRCULAR SAW
BLADE FOR USE ON THIS ANGLE GRINDER. NEVER INSTALL A WOOD CARVING
BLADE, CARVING DISC WITH SAW CHAIN CUTTERS, OR A CUTTING CARVING
DISC ON THIS ANGLE GRINDER.
REV 05/03