Filter
Top Products
3. By changing the tool post angle and adjusting the compound rest, you can do internal cutting
(figure 15).
4. After adjusting the angle of the compound rest, you can do bevel cutting (figure 16).
Set-Up Instructions for Threading Gears
By changing the gear set-up it is possible to cut any thread size. The factory set-up for Mini Lathe
gears is as follows (see illustration below):
To change the thread size, use the gear box settings shown on the table on the next page.
B
D
D
A A
C C B
Position A= 20T
Position B= 80T
Position C= 20T
Position D= 80T
SKU #33684 Page 10