Filter
Top Products
Additional Safety Rules for Mini Lathe
1. Before turning on the motor, make sure
that proper lubrication is included (see page
of this manual).
2. Always dismount the chuck and lathe’s
face plate by hand. Do not use power tools
to perform these tasks.
3. After the chuck is installed, remove the
wrenches and tools to eliminate the possi-
bility of accident when the lathe is turned
on.
4. Never adjust or fix workpieces or any
rotating parts when the lathe is on. Never
use instruments to measure the workpiece
when the lathe is on. Never check the
sharpness of the cutter by using your hand.
5. Avoid accidents resulting from broken
workpieces. Never use an excessively large
tool cutter to do feeding with a large
workpiece.
6.Never change the gear when the lathe is in
operation.
7. Always keep a safe distance from the lathe
to minimize the risk of being struck by a
broken workpiece.
____________________________________________________________________________
Thank you for choosing a Harbor Freight Tools product! For future reference, please
complete the owner’s record below:
Model:_______________ Serial Number:_________________ PurchaseDate:__________
SAVE THE RECEIPT, WARRANTY AND THESE INSTRUCTIONS. It is important that you
read the entire manual to become familiar with the unit BEFORE you begin assembly.
____________________________________________________________________________
Technical Specifications
Motor: 3/4 Horsepower
Power Source: 110V, Single Phase
Lathe Specifications:
Drive: Gear and Belt
Swing Over Bed: 7”
Distance Between Centers: 10”
Spindle Bore: 3/4”
Quill Travel: 2”
Cross Slide Travel: 2 3/4”
Cross Slide Swing: 4 1/2”
Work Tolerance: .005”
Bed Dimensions: 15 7/8” long, 3 1/4” wide
Saddle Travel: 6 7/8”
Compound Travel: 2 7/8”
SKU #33684 Page 4