Filter
Top Products
Page 11SKU 37793 For technical questions, please call 1-800-444-3353.
Adjust the Straight Guide by turning the Fine Adjustment Screw (A) to the desired
distance from the bit.
Tighten wing nuts (C).
When cutting, move the router with the Straight Guide at against the side of the
material to be chamfered or grooved. See gure.
Note: Standoffs can be mounted to the Straight Guide to widen its operation. This also
prevents larger bits from striking the Straight Guide.
Using the Trimmer Guide
The Trimmer Guide (3A) is used to make cuts on curved material. The guide roller
rides the curve of the material.
Trimmer Guide (3A)
Fine Adjustment
Screw (A)
Wing Nut (B)
Place the Trimmer Guide (3A) on the Guide Holder with the wing nut.
Insert Guide Holder into the holes in the router base.
Adjust the Trimmer Guide by turning the Fine Adjustment Screw (A) to the desired
distance from the bit.
Tighten Wing Nut (B).
3.
4.
5.
1.
2.
3.
4.