Filter
Top Products
For technical questions, please call 1-800-444-3353.SKU 38123 Page 18
F. Tighten the three Screws firmly. (See Figure Q.)
G. Grasp the Drive Belt (43) with two fingers on the outside-center and squeeze. There
should be about 1/4” give to the Drive Belt for proper tension. (See Figure Q.)
H. Note: Too much tension on the Drive Belt (43) can load-down the Motor and cause
possible damage. If the Drive Belt is too loose, it may fail prematurely.
(See Figure Q.)
I. Make sure to replace the Belt Cover (52). (See Figure Q.)
7. When storing: Store the Sander in a safe, clean, dry, location out of reach of children
and other unauthorized people.
8. WARNING! All maintenance, service, or repairs not listed in this manual are only
to be attempted by a qualified service technician.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIA-
GRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBU-
TOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS
QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE
ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY
STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED
AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK AND LIABIL-
ITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
DRIVE BELT (43)
DRIVE PULLEY (46)
DRIVE PULLEY (49)
LOOSEN
THREE SCREWS
FIGURE Q
BELT COVER (52)