Filter
Top Products
Page 5For technical questions, please call 1-800-444-3353.SKU’s 40072,
40073, & 97521
SPECIFIC SAFETY
INSTRUCTIONS
Operators and others in work area 1.
MUST wear ANSI-approved safety
goggles with side shields during use.
The employer is responsible to enforce
the use of eye protection by the operator
and others in the work area.
Keep ngers away from trigger 2.
when not driving fasteners to avoid
accidental ring.
Choice of triggering method is 3.
important. Check manual for
triggering options.
Always assume the tool contains 4.
fasteners.
Do not point the tool toward yourself or 5.
anyone whether it contains fasteners or
not.
Do not actuate the tool unless the tool is 6.
placed rmly against the workpiece.
Respect the tool as a working implement.7.
No horseplay. This tool is not a toy and 8.
can be deadly if misused.
Do not load the tool with fasteners when 9.
any one of the operating controls, such
as the Trigger or Safety Nosepiece, is
activated.
Do not remove, tamper with, or otherwise 10.
cause the tool operating controls to
become inoperable.
Do not operate the tool if any portion of 11.
the tool operating controls is inoperable,
disconnected, altered, or not working
properly.
Disconnect the tool from the air supply 12.
when:
Unattended.a.
Performing any maintenance or repair.b.
Clearing a jam.c.
Moving the tool to a new location.d.
Do not make any modications to this 13.
tool.
Refer to the tool maintenance 14.
instructions for detailed information on
the proper maintenance of the tool.
Fire fasteners into an appropriate 15.
work surface only. Do not attempt to
re fasteners into surfaces too hard to
penetrate. Do not drive fasteners on top
of other fasteners, or at too steep of an
angle. Fasteners can ricochet causing
personal injury.
Do not re fasteners too close to the 16.
edge of a workpiece. They may split the
workpiece and y free, causing personal
injury.
Keep clear of the workpiece near the 17.
area being fastened. Fasteners may
bend sideways during ring, causing
them to exit the workpiece at an
unexpected point, causing personal
injury.
Transport Tool safely. Always disconnect 18.
air supply when moving the tool. Carry
the tool by the handle and avoid contact
with the trigger.
Hold tool away from head and body. 19.
During operation the Tool may kick back
causing injury.
Do not re fasteners into a workpiece 20.
that has people, utility lines, or other
objects behind or inside it.
Keep balance while using this tool. 21.
Keep area below clear if working in
an elevated location, and secure air
hose to prevent falls from bystanders
accidentally pulling on it.