Filter
Top Products
Page 8 For technical questions, please call 1-800-444-3353. SKU’s 40072,
40073, & 97521
With the Trigger held, carefully lift the
nailer and press it against the workpiece
again. The tool must not cycle (re).
If it fails to act in the manner explained
in bold, have it repaired by a qualied
service technician.
Loading Staples
ALWAYS WEAR ANSI APPROVED
IMPACT SAFETY GOGGLES
WHEN RELOADING OR DOING
ANY OTHER MAINTENANCE ON
THIS TOOL. Other people in the
work area must also wear ANSI
approved impact safety goggles.
Warning! Make sure the Stapler is not attached
to the air hose whenever loading the tool.
Release the Latch (69) and pull back on 1.
Magazine B (61).
Insert a row of clean, undamaged 2.
staples with the crowns up.
Push Magazine B (61) forward until the 3.
Latch (69) snaps into place.
Operating the Stapler
Attach the Stapler to the air supply at the 1.
Air Plug (82). Start your compressor and
check the pressure, making sure it is set
at the recommended 60-100 PSI and not
to go over the maximum 100 PSI.
To re, place the nose of the Stapler on 2.
the workpiece. The Stapler should not
re if the nose is not depressed. Once
depressed, gently and briey squeeze
the Trigger (39) once. Do not re
repeatedly. Staples could bounce off
of one another, damaging the work
piece or causing PERSONAL INJURY.
After disconnecting the Stapler, the Nut 3.
(39), near the trigger, can be turned to
adjust the depth. After adjusting, be sure
to practice on scrap wood before working
on a project.
Clearing Jams
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL OPERATION,
BEFORE ANY MAINTENANCE OR
REPAIRS ARE DONE (including
clearing jams):
• Wear ANSI-approved safety
goggles with side shields. Other
people in the work area must also
wear ANSI-approved impact safety
goggles with side shields.
Release the trigger.•
Detach the air supply.•
Attempt to re the Tool into a •
piece of scrap wood to ensure
that it is disconnected and is
incapable of ring any fasteners.
Empty the magazine and leave it •
open during service.
Disconnect tool from air hose, empty 1.
Magazine A (66) of staples, release
any built-up air pressure, and leave the
magazine open, as explained above.
Safety Cover
Bolt (53)
FIGURE 1
2. While doing this step and the next, hold
the Stapler pointed away from you and
any other people or fragile objects - see
Figure 1. Remove all three Safety Cover
Bolts (53) on the Safety Cover (54).