Filter
Top Products
Page 16SKU 42654
For technical questions, please call 1-800-444-3353.
that the springs on the Carbon Brushes operate freely. Be sure the carbon portion
of the Carbon Brushes contacts the motor’s Rotor (102), and the springs face away
from the Rotor. After inspection or replacement, replace the Brush Boxes with a
screwdriver and tighten firmly. (See Assy. Diagram.)
With a brush, soft cloth, or vacuum, remove all sawdust from the Compound Miter
Saw.
Do not use solvents to wipe off the Compound Miter Saw, as damage may result.
If necessary, wipe with a damp cloth. You may use a mild detergent.
Do not introduce water or other liquids into the electric motor through the motor
vents.
Once clean, lubricate all moving parts with a light weight oil.
When storing, keep the Compound Miter Saw covered with a cloth cover.
4.
5.
6.
7.
8.
REV 07/02
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE
IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALIFIED TO
REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR DISTRIBUTOR
EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN
BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES
ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT
OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
PLEASE READ THE FOLLOWING CAREFULLY