Filter
Top Products
Page 4SKU 42654
For technical questions, please call 1-800-444-3353.
SPECIFIC PRODUCT WARNINGS AND PRECAUTIONS
MAKE SURE THE POWER SWITCH (82) IS IN THE “OFF” POSITION BEFORE
PLUGGING IN THE POWER CABLE (93).
DO NOT ABUSE THE POWER CABLE. Do not use the Power Cable (93) to pull
the Plug from a power outlet. Keep the Power Cable away from heat, oil, sharp
edges, and moving parts. Replace a damaged Power Cable immediately. Route
the Power Cable safely. Protect it from being damaged by other equipment in the
shop. Do not route the Power Cable where it can be walked on or tripped over.
RECOMMENDED MINIMUM WIRE GAUGE FOR EXTENSION CORDS*
(120 OR 240 VOLT)
NAMEPLATE
AMPERES
(at full load)
EXTENSION CORD LENGTH
25 Feet 50 Feet 75 Feet 100 Feet 150 Feet
0 – 2.0 18 18 18 18 16
2.1 – 3.4 18 18 18 16 14
3.5 – 5.0 18 18 16 14 12
5.1 – 7.0 18 16 14 12 12
7.1 – 12.0 18 14 12 10 -
12.1 – 16.0 14 12 10 - -
16.1 – 20.0 12 10 - - -
FIGURE C
* Based on limiting the line voltage drop to five volts at 150% of the rated amperes.
IF YOU USE AN EXTENSION CORD, MAKE SURE TO USE ONLY UL LISTED
CORDS HAVING THE CORRECT GAUGE AND LENGTH. (SEE BELOW.)
MAINTAIN A SAFE WORK ENVIRONMENT. Do not use this product in or near damp
or wet areas. Do not expose this product to rain. Keep the work area well lit. Make
sure there is adequate surrounding workspace. Use this product in a well ventilated
area. Do not operate this product in the presence of flammable liquids, gases, or
dust. To avoid accidental electric shock, do not let your body come in contact with
grounded surfaces such as pipes, radiators, ranges and refrigerators.
DO NOT FORCE THE EQUIPMENT. The Compound Miter Saw will do the work
better and safer at the speed and capacity for which it was designed.
KEEP ALL GUARDS IN PLACE AND IN WORKING ORDER.
REMOVE ALL ADJUSTING WRENCHES FROM THE COMPOUND MITER SAW
BEFORE TURNING IT ON.
AVOID UNINTENTIONAL STARTING. Make sure you are prepared to begin work
before turning the Power Switch (82) “ON”.
1.
2.
3.
4.
5.
6.
7.
8.