Filter
Top Products
SPECIFICATIONS
INCLUDED ACCESSORIES
4, 5 and 6mm Hex Wrenches
Drift Pin
Drill Chuck
Chuck Key
Stand Assembly
Precision 0-70
O
vise
FEATURES
1. This machine may be used for surface cutting, drilling, milling, and tapping.
2. The high quality of this machine, and its ease of operation makes it suitable for use by students,
amateurs, and home hobbyists, as well as skilled technicians.
3. Drilling and milling may be done using hand operated feeding. Milling is done with the quill locked via
Clamp Handle (#83) *.
4. Many of the adjustable nuts are bronze, for adjusting thread clearance and reducing wear. These
bronze parts also allow screws to rotate smoothly and improve accuracy.
5. The vertical column is very strong and stiff, which makes the machine very stable and improves
accuracy of manufactured parts.
6. The machine head is cast steel, and has been heat-treated, stress-relieved, and precision machined.
7. Machine gears are precision ground for smooth operation.
8. Speeds can be easily changed.
9. Thread tapping operations can be done in either rotation, and working depth can be controlled using a
positive stop gauge.
Page 2 SKU # 42976
SAVE THIS MANUAL
You will need the manual for the safety warnings and cautions, assembly instructions, operating procedures,
maintenance procedures, trouble shooting, parts list, and diagram. Keep your invoice with this manual.
Write the invoice number on the inside of the front cover. Keep both this manual and your invoice in a safe,
dry place for future reference.
* For fine adjustment, use a dial test indicator (not included) mounted either to the table or workpiece, and
reference a point on the chuck or quill colar that is convenient. Loosen the Clamp Handle (#83) slightly,
then tap the chuck feed lever lightly, as you observe the indicator dial.
Motor: 120V/60Hz Single Phase
1/2 HP, 8.5 Amps with Load
12 Speeds (rpm): 300-400-540-720-900-
1040-1500-1740-2100-2260-3100-3840
Motor rpm’s: 1700
Drive Type: V-belt / Pulley
Spindle Taper: MT-2, Diameter: 1.265”
Spindle Stroke: 3-3/8”
Drill Capacity: 5/8”
Face Mill Capacity: 1-1/2”
End Mill Capacity: 5/8”
Max. Chuck to Table: 10”
Column Diameter: 2.830”
Table Slots: 1/2” x 2
Head Rotation: 360
O
Net Weight: 470 Lbs.
NOTICE
The Warnings, Cautions, and Instructions discussed in this instruction manual cannot
cover all possible conditions and situations that may occur. It must be understood by
the operator that common sense and caution are factors which cannot be built into this
product, but must be supplied by the operator.
REV 08/03