Filter
Top Products
Page 8 SKU # 42976
BASIC OPERATION
For reference numbers mentioned in these instructions, please see page 5.
WARNING: Unplug the drill from its power source before changing bits or attempting any repairs,
adjustments or maintenance.
Basic Controls
1. Raise and lower the Head by using the Head Crank (#3).
2. Feed the Chuck (#9) using the Chuck Feed Lever (#5).
Chuck movement may be limited using the Chuck
Travel Limit Screw (#6).
3. Move or feed the Table from side to side using either
Horizontal Feed Control Wheels (#20).
4. Move the Table front to back using the Cross Feed
Control Wheel (#21).
5. Attach workpieces to the Table using jigs or fixtures
(not included) or the included precision 70
O
vise
attached to the T-slots (#23).
6. The machine can be turned ON and OFF by using
the power switch located on the left side of the
Head. The upper Switch marked
||
||
| turns the machine
ON. The lower switch marked O turns the
machine OFF.
WARNING: The machine will continue to run as long
as the power cord is plugged in, and the switch is
turned ON. Never leave the machine unattended while
it is running.
Installing the Chuck
The Chuck and Chuck Spindle both have a self-centering MT-2 taper.
1. Wipe a small amount of grease onto the spindle to prevent corrosion.
2. Place the chuck onto the spindle, pressing it upward with a twisting motion. Tap the chuck gently home,
using a soft-faced mallet.
3. If desired, fine tune the chuck using a dial indicator. To do this, mount a dial indicator firmly on the table.
Place the dial indicator pointer in contact with the chuck, and adjust the dial to zero. Slowly rotate the
chuck and read any out of center on the indicator. Carefully tap the chuck with a mallet upward and to
the side as needed to center the chuck. Continue this process until you are satisfied with the adjustment.
To insert and remove drill or milling bits, use the chuck key provided.
1. Insert the Chuck Key into one of the holes in the Chuck, so that it meshes with the cogs on the Chuck.
2. Turn the Chuck Key counterclockwise to open the flanges in the Chuck. Continue to turn the Chuck
Key until the opening is large enough to accept the Bit.
NOTE: the largest bit size capacity of this Chuck is 5/8” diameter.
3. Insert the Drill Bit into the Chuck.
4. Turn the Chuck Key clockwise to tighten the jaws around the drill bit shaft. Ensure that the drill bit is
seated securely before starting.
5. Remove the Chuck Key, and replace it in its holder before starting.
Figure 2. Drill Head Controls