Filter
Top Products
Page 4SKU 43681
For technical questions, please call 1-800-444-3353.
AVOID UNINTENTIONAL STARTING. Be sure that you are prepared to begin work
before turning the start switch on.
STAY ALERT. Watch what you are doing. Do not operate this machine when you are
tired.
DO NOT OPERATE THIS MACHINE WHILE UNDER THE INFLUENCE OF ALCOHOL,
DRUGS, OR PRESCRIPTION MEDICINES.
CHECK FOR DAMAGED PARTS. Before using any tool, any part that appears damaged
should be carefully checked to determine that it will operate properly and perform its
intended function. Check for alignment and binding of moving parts, any broken parts
or mounting fixtures, and any other condition that may affect proper operation. Any part
that is damaged should be properly repaired or replaced by a qualified technician. Do
not use the tool if any switch does not turn on and off properly.
REPLACEMENT PARTS AND ACCESSORIES. When servicing, use only identical
replacement parts intended for use with this tool. Replacement parts are available from
Harbor Freight Tools. Use of any other parts will void the warranty.
SPECIAL WARNINGS WHEN USING THIS BENCH LATHE
Using this Bench Lathe may create special hazards.
Take particular care to safeguard yourself and those around you.
Electrical Safety. Never operate any tool if there is an electrical hazard. Never oper-
ate an electrical tool in wet conditions. Never operate a tool with an improper electrical cord
or extension cord. Never operate an electrical tool unless you are plugged into a properly
grounded outlet, which
supplies 115 Volts at 60 Hz. We recommend you use a circuit
which is protected by an appropriate circuit breaker.
Ejected Material. Use safe practices to avoid injury from ejected material. Because the
lathe and the workpieces turn at high speed, there is a danger of being injured by materi-
als that may be ejected. Always wear ANSI-certified eye protection. Never attempt to work
on any item if it is not adequately held. Always stand to one side of the plane in which the
materials are spinning, to avoid being hit if an item is ejected. Never allow bystanders to be
in the proximity of the lathe while in operation.
Entanglement. Use extreme caution to prevent loose materials from being caught in
the machine. Never operate this lathe with loose clothing, long hair, jewelry, or other items
which may become caught in the tools or workpieces. In case of entanglement, press the
OFF switch immediately.
NOTICE: No list of warnings can be all inclusive. The operator must supply
common sense, and operate this tool in a safe manner.
13.
14.
15.
16.
17.