Filter
Top Products
Page 9SKU 45861 For technical questions, please call 1-800-444-3353.
SPECIFICATIONS
Electrical Requirements 120 V~ / 60 Hz
Lathe Type Metal Cutting
Motor 3/4 HP
Motor Speed 1790 RPM
Spindle Speed
120, 320, 420, 620,
1130 & 2000
Spindle Taper MT-3
Spindle Bore 3/4”
Chuck 3 Jaw
Chuck Capacity 4”
Tail Stock Quill Travel 1-3/4”
Tail Stock Quill Taper MT-2
Tool Post Capacity 3/4”
Swing Over Bed 9”
Distance Between Centers 20”
UNPACKING
When unpacking, check to make sure
that the item is intact and undamaged. If
any parts are missing or broken, please
call Harbor Freight Tools at the number
shown on the cover of this manual as soon
as possible.
Proper lubrication is essential. To
be safe, and to become more familiar with
the Lathe, disassemble the lathe entirely,
then clean and lubricate each part with
white lithium grease before rst use.
List of contents
Description Qty
9” X 20” Bench Lathe 1
4” 3-Jaw Chuck 1
Reverse Jaws For Chuck. 3
Chuck Wrench 1
Dead Center Mt#2 1
Dead Center Mt#3 1
Live Center 1
10-12 Open-End Wrench 1
14-17 Open-End Wrench 1
Description Qty
17-19 Open-End Wrench 1
Round Nut Wrench 45-52 1
Tool Post Wrench 1
Hex Wrenches - 3, 4, 5, 6mm 1 ea.
Drive Belts 2
Threading Gear Set 28,30, 36,42,45 & 80T 1
Oil Can 1
Splash Guard 1
Operators Manual 1
INSTRUCTIONS FOR
PUTTING INTO USE
Read the ENTIRE IMPORTANT
SAFETY INFORMATION section
at the beginning of this manual
including all text under
subheadings therein before set
up or use of this product.
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
assembling or making any
adjustments to the tool.
Note: For additional information regarding
the parts listed in the following pages,
refer to the Assembly Diagram near
the end of this manual.
Mounting
Unbolt and remove the Lathe from 1.
the crate.
The Lathe will need to be mounted 2.
to a surface capable of bearing the
combined weight of the Lathe and
intended workpieces. The surface
must be able to withstand the vibra-