Filter
Top Products
SKU 46225 For technical questions, please call 1-800-444-3353. Page 6
4. Plug the Pump [59] into the back of the Motor and attach the Pump to the
Water Tank using the four suction feet on the bottom of the Pump. See Fig. 2 on
Page 11.
5. Slide the Table Holder [51] through the middle of the Rail Cover [47] and fit the
two Inserts [45] over the ends of the Cover to prevent the Table Holder from
slipping out.
6. Attach the Rail and Table [52] Assembly you created in Step 5 to the Frame
using two sets of the Bolts [3], Flat Washers [4] and Teeth Washers [5] as
shown in the Assembly Diagram.
7. Before operating this tool, mount the Table Saw to the Table Stand (SKU #46310,
sold separately) by following the steps outlined in the Assembly and Operating
Instructions for the Table Stand. If the Stand is not to be used with the Tile Saw,
the Saw must be securely mounted onto a flat, level surface capable of
supporting the weight of the Tile Saw in addition to the weight of all work pieces.
Changing/Installing the Blade
1. Be sure the Power Cord is unplugged from its power source.
2. Loosen the Locking Knob located on the side of the Blade Guard [20] and
raise Guard. Tighten the Knob to lock the Guard in an “up” position.
3. Depress the Brake Shaft Button [26] (See Fig. 1 on Page 10) while turning the
Blade (or Spindle [44] if you have not yet installed a Blade) with your hand until
the Shaft button depresses fully. This will prevent the Spindle from spinning
and allow you to unscrew the Nut [29] and Outer Flange [30].
4. Slide the new Blade over the Spindle, and refasten the Outer Flange and Nut.
Be sure to tighten the Nut fully before use.
5. Lower the Blade Guard and tighten the Locking Knob.
Installing the Water Supply
To prevent excessive wear on the Blade, be sure to maintain a continuous flow of
water over the Blade while cutting. Never cut anything if the water flow is not con-
tinuous.
1. Attach the Pump as described in Step 4, “Assembly.” Position the Pump so it
will not interfere with the motion of the Table while cutting.
2. Fill the Water Tank with enough water so that the Pump is completely
submerged, but not so much water that the Tank overflows.
Note: When using the Tile Saw, extreme care must be taken to insure that the
Saw’s Power Cord is positioned to remain dry and free from water at all times.
Severe personal injury or death can occur if the Power Cord or the operator of
this tool should become wet at any time while this tool is in use. Care and
common sense must be used in planning a safe work area.