Filter
Top Products
SKU 46225 For technical questions, please call 1-800-444-3353. Page 9
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIA-
GRAM IN THIS MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER
NOR DISTRIBUTOR MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO
THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT
OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN
FACT, THE MANUFACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL
REPAIRS AND PARTS REPLACEMENTS SHOULD BE UNDERTAKEN BY CERTIFIED AND
LICENSED TECHNICIANS AND NOT BY THE BUYER. THE BUYER ASSUMES ALL RISK
AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR
REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF
REPLACEMENT PARTS THERETO.
2. Inspect the Mounting Screws on all safety covers, and the Arbor Nut on the
Cutting Wheel Shaft. Tighten any that appear loose.
3. Protect the Motor and electrical components from prolonged or excessive
exposure to water or wet conditions. Wipe the unit dry as needed.
4. Periodically apply a light lubricant to the Rail Cover.
5. Note: The Pump is non-serviceable. If it should fail, first try clearing the intake
of debris and be sure the hole is not plugged.
6. To clean the Pump Filter, remove the front cover and impeller. See Figure A.
7. Ue a small brush or stream of water to remove any debris.
8. If the Pump is used on a dirty surface, raise it slightly to reduce the amount of
debris entering the intake.
9. Adjust the Flow Control on the end of the Pump to restrict flow.
10. Do not let the Pump run when it is not submerged in water. Running the Pump
out of the water will damage the Pump.
11. If the Pump still does not work, it must be replaced. Replacement Pumps are
available through Harbor Freight Tools.
REV 08/06
Figure A