Filter
Top Products
SKU 46507 PAGE 10
parts and any other condition that may affect its safe operation. If abnormal
noise or vibration occurs, turn off the Polisher/Sander immediately and have the
problem corrected before further use. Do not use damaged equipment.
3. The Polisher/Sander features
two
Carbon Brushes (part #41) which, periodically,
should be examined for wear. The Carbon Brushes are located on each side of
the Plastic Housing (part #29). To inspect or replace the Carbon Brushes, use a
small standard screwdriver to remove the Brush Cap (part #40). Examine the
concave surface of the Carbon Brushes. The surface should be smooth and
clean. If there are large scratch marks in the Brushes, or parts of the Brushes
have broken off, replace
both
Brushes immediately with approved replacement
Brushes from Harbor Freight Tools. To reinstall the Brushes, insert them into the
two
Brush Holders (part #42). Turn the Brushes vertically so they will fit into the
Brush Holders. Then, replace the Brush Caps. (See Figures B, C, and Assy.
Diagram.)
4. Do not use solvents to wipe off the Polisher/Sander, as damage may result. If
necessary, wipe with a damp cloth. You may use a mild detergent.
5. Do not introduce water, dirt, or dust into the electric motor through the motor
vents.
6. Once clean, lubricate all moving parts with a light oil.
7. When storing, keep the Polisher/Sander covered with a cloth cover.
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER NOR DISTRIBUTOR
MAKES ANY REPRESENTATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR
SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE PRODUCT OR THAT HE OR SHE IS QUALI-
FIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANUFACTURER AND/OR
DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD
BE UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS AND NOT BY THE BUYER. THE
BUYER ASSUMES ALL RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE
ORIGINAL PRODUCT OR REPLACEMENT PARTS THERETO, OR ARISING OUT OF HIS OR HER
INSTALLATION OF REPLACEMENT PARTS THERETO.