Filter
Top Products
SKU 46507 PAGE 7
To Attach The Rubber Backing Plate And Sandpaper:
1. Caution: Prior to installing the Rubber Backing Plate (part #46), make sure the
Polisher/Sander is disconnected from its electrical power source.
2. Rest the tool on a flat surface. Depress the Brake Pin (#18) to keep the Spindle
(#3) from turning.
3. Screw the Rubber Backing Plate (46) onto the threaded end of the Spindle (#3)
until it is snug. (See diagram below)
4. Ahere Sandpaper Disc (not included) evenly across the Rubber Backing Plate.
The Rubber Backing Plate has a self-sticking backing, so be sure only to use
Sandpaper Discs with a self-sticking material. Press Sandpaper Disc firmly onto
pad. When finished, release pressure on the Brake Pin (#18).
5. When finished sanding, peel the Sandpaper Disc away from the Plate.
BRAKE PIN (#18)
RUBBER BACKING PLATE (#46)
SPINDLE (#3)
SANDPAPER DISC