Filter
Top Products
Sku 46766 For technical questions, please call 1-800-444-3353. Page 3
7. Dress properly. Do not wear loose clothing or jewelry as they can be caught in moving parts.
Protective, electrically nonconductive clothes and nonskid footwear are recommended when working.
Wear restrictive hair covering to contain long hair.
8. Use eye and ear protection. Always wear ANSI approved impact safety goggles. Wear a full face shield
if you are producing metal filings or wood chips. Wear an ANSI approved dust mask or respirator when
working around metal, wood, and chemical dusts and mists.
9. Do not overreach. Keep proper footing and balance at all times. Do not reach over or across running
machines.
10. Maintain products with care. Keep products clean for better and safer performance. Follow
instructions for lubricating and changing accessories.
11. Remove adjusting keys and wrenches. Check that keys and adjusting wrenches are removed from
the tool or machine work surface before operating.
12. Stay alert. Watch what you are doing, use common sense. Do not operate any tool when you are tired.
13. Check for damaged parts. Before using any product, any part that appears damaged should be
carefully checked to determine that it will operate properly and perform its intended function. Check for
alignment and binding of moving parts; any broken parts or mounting fixtures; and any other condition
that may affect proper operation. Any part that is damaged should be properly repaired or replaced by a
qualified technician.
14. Replacement parts and accessories. When servicing, use only identical replacement parts. Use of
any other parts will void the warranty. Only use accessories intended for use with this tool. Approved
accessories are available from Harbor Freight Tools.
15. Do not operate product if under the influence of alcohol or drugs. Read warning labels on
prescriptions to determine if your judgment or reflexes are impaired while taking drugs. If there is any
doubt, do not operate the tool.
16. Maintenance. For your safety, service and maintenance should be performed regularly by a qualified
technician.
17. Do not exceed the products 4,000 Lb. maximum capacity. Exceeding the maximum capacity may
cause damage to the product and may result in serious harm or injury.
18. Make certain to place the Shop Crane on a flat, sturdy and level surface that is capable of
supporting the weight of the Shop Crane and a 4,000 Lb. Load.
Warning: The warnings, cautions, and instructions discussed in this instruction manual cannot cover
all possible conditions and situations that may occur. It must be understood by the operator that
common sense and caution are factors which cannot be built into this product, but must be supplied
by the operator.
Safety Warnings (cont’d)
REV 11/02; 05/05
Assembly
Your Foldable Shop Crane will require complete assembly as described in the following steps. To assist you
with assembly and operation please refer to the Operational Figures as well as the Assembly Diagram and
Parts List located on the last pages of this manual.
Warning: Due to the weight of the Shop Crane, assistance during assembly is recommended.
Step 1) Line up the holes in each mid size Caster Wheel (5) with the holes on the Base (4). One mid
size Caster Wheel (5) is to be attached to each side of the Base (4). For each mid size Caster
Wheel (5), slide four (4) Bolts (28) up through a Spring Washer (7) and into Base (4).