Filter
Top Products
Page 4SKU 47404 For technical questions, please call 1-800-444-3353.
2. GROUND THIS PRODUCT. The electrical Power Cord/Plug (part #34) for this
product is equipped with a grounded, 3-prong Plug. Never remove the grounding
prong or modify the Plug in any way. Do not use adapter plugs with this product.
To comply with the National Electric Code, and to provide additional protection
from the risk of electrical shock, this product should only be connected to a 120
Volt, 3-hole electrical outlet that is protected by a Ground Fault Circuit Interrupter
(GFCI). (See Assy. Diagram.)
3. IF AN EXTENSION CORD (not provided) IS USED, MAKE SURE TO USE
ONLY UL APPROVED CORDS HAVING THE CORRECT GAUGE AND
LENGTH. (See Figure A.)
FIGURE A
AWG RATING CHART - 120 VOLT
4. PROPERLY ALIGN THE WORK TABLE (part #7). Make sure the distance
between the Work Table and Sanding Disc (part #14) does not exceed 1/16”.
5. REDUCE THE RISK OF ACCIDENTAL STARTING. Make sure the Safety Switch
(part #32) is in the “OFF” position before plugging the Power Cord/Plug (part #34)
into a grounded, 3-hole, 120 Volt, electrical outlet.
(See Figure B, and Assy. Diagram.)
6. PRIOR TO STARTING THE DISC SANDER, MAKE SURE ALL ADJUSTING
KEYS AND WRENCHES ARE REMOVED FROM THE TOOL.
7. ALWAYS FEED THE WORKPIECE INTO AND AGAINST THE DIRECTION OF
THE ROTATING SANDING DISC (part #14).
8. NEVER STAND OR HAVE AN OBSERVER STAND IN LINE WITH THE
SPINNING SANDING DISC (part #14).
9. USE THE PROPER SIZE AND TYPE OF SANDING DISC (10”, PRESSURE
SENSITIVE ADHESIVE).
10. HOLD THE WORKPIECE FIRMLY SO THAT IT WILL NOT BE PULLED FROM
YOUR HANDS DURING THE SANDING PROCESS.
11. FEED THE MATERIAL GRADUALLY. Do not force the machine to remove