Filter
Top Products
Page 8SKU 47612 For technical questions, please call 1-800-444-3353.
Operating the Nailer
ALWAYS WEAR ANSI APPROVED IMPACT SAFETY GOGGLES WHEN
RELOADING OR DOING ANY OTHER MAINTENANCE ON THIS TOOL.
Other people in the work area must also wear ANSI approved impact safety
goggles.
Attach the Nailer to the air supply at the Air Inlet (57). Start your compressor and 1.
check the pressure making sure it is set at the recommended 70-120 PSI.
Rotate the Deector (6) so that the exhaust air blast will be directed away from the 2.
operator.
To re, place the Nose Cushion (89) of the Nailer on the workpiece. With the 3.
Trigger (47), Nails can only be driven one way. First, depress the Nose Cushion
against the workpiece. Then, pull the Trigger. The Nailer should not re if the
Nose Cushion is not depressed. This feature is helpful when precise fastener
placement is required. Also, it may reduce the possibility of injury to you or to oth-
ers working with you.
Do not press the Nose Cushion (89) against the work surface with extra force. Al-4.
low the tool to do the work. Always allow the tool to recoil off the work surface.
When nished using the Nailer, always disconnect the tool from its compressed 5.
air supply. Empty the Magazine (69) completely of nails. Attempt to re the Nailer
into a piece of scrap wood to ensure it is disconnected and is incapable of ring
any nails.
Make sure to store the Nailer in its accessory Carrying Case and in a clean, dry, 6.
safe location out of reach of children.
REV 06k