Filter
Top Products
SKU 66399 For technical questions, please call 1-800-444-3353. Page 6
1. The air hose must be long enough
to reach the work area with enough
extra length to allow free movement
while working.
2. Turn the tool’s On/Off switch to the
“OFF” position; refer to Operation
section for description of controls.
3. Inspect the air connections for leaks.
Repair any leaks found.
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Inspect tool before use, looking
for damaged, loose, and
missing parts. If any problems
are found, do not use tool until
repaired.
Tool Set Up
TO PREVENT
SERIOUS INJURY:
Do not adjust or tamper with
any control or component in a
way not specically explained
within this manual. Improper
adjustment can result in tool
failure or other serious
hazards.
Work Piece and Work Area Set Up
Designate a work area that is clean 1.
and well-lit. The work area must not
allow access by children or pets to
prevent distraction and injury.
Route the air hose along a safe route 2.
to reach the work area without creat-
ing a tripping hazard or exposing the
air hose to possible damage. The air
hose must be long enough to reach
the work area with enough extra
length to allow free movement while
working.
General Assembly and Operating
Instructions
Set tool on a dry, at, level surface. 1.
To prevent accidents, turn the On/Off 2.
Switch (25) to the “OFF” position.
Attach the quick coupler of coiled Air 3.
Hose (59) to male connector at the
end of Rubber Hose (53).
NOTE: 4. Be sure to pull back on collar
of Air Hose’s coupler. Then rmly
insert connector into coupler. (See
Figure 1.) Release collar, which will
snap connector in place. Pull lightly
on both hoses to ensure proper
locking in the coupler.
Attach the clamps on the Power Cord 5.
(27) onto the 12V automotive battery
(not included) power source.
Connect RED clamp of the Com-a.
pressor to the positive (+) terminal of
the battery.
REV 10a
Fig. 1
Air House (59)
Coupler Collar
Male
Connector