Filter
Top Products
SKU 91938 For technical questions, please call 1-800-444-3353. Page 12
Clamp and Angle Scale
1. To use the Quick Release (31), put the Quick Release (31) tab in the position
shown in FIGURE 4 and push the Vise Handle (28) up against the workpiece.
Then tighten the Vise Handle (28). When releasing, loosen the Vise Handle (28)
a few turns, lift up the Quick Release (31), and pull the Vise Handle (28) open.
2. To cut at various angles (up to 45 degrees), adjust the Angle Scale (35) by loos-
ening the two Screws (41 & 44) as shown in FIGURE 5. Adjust the Angle Scale
to the desired setting and then tighten the Screws (41 & 44).
3. To reposition the Angle Scale (35), remove both of the Screws (41 & 44), and
reattach the Angle Scale at the upper two screw holes. See FIGURE 4.
Locking Down the Saw
1. To lock down the Saw, push the Saw down as far
as it will go, and then push the Lock Ball (25) in.
2. To raise the Saw, push down on the Saw and pull
out the Lock Ball (25).
Depth Adjustment
To adjust the depth either up or down, adjust the
Depth Adjustment Bolt (16) shown in FIGURE 3.
Screws (41 & 44)
Vise Handle (28)
Place Workpiece Here
FIGURE 4
FIGURE 5
Angle
Scale
(35)
Quick
Release (31)
Upper Two Screw Holes
FIGURE 3
Lock Ball (25)
Depth Adjustment
Bolt (16)