Harbor Freight Tools 92386 Saw User Manual


 
SKU 92386 For technical questions, please call 1-800-444-3353. Page 10
The Saw Blade will become hot while cutting. Allow the Saw Blade to com-
pletely cool before handling.
Allow the Saw Blade to spin up to full speed before feeding a workpiece into
it. When turning off the Tile Saw, allow the Saw Blade to spin down and stop on its
own. Do not press against the Saw Blade to stop it.
Do not force the workpiece into the Saw Blade when cutting. Apply moder-ate
pressure, allowing the Saw Blade to cut without being forced.
Turn off the Tile Saw and allow the Saw Blade to stop on its own if the Saw
Blade is to be backed out of an uncompleted cut.
Never attempt to remove material stuck in the moving parts of the Tile Saw
while it is plugged in and running.
When cutting a large workpiece make sure its entire length is properly sup-
ported. If necessary, use a roller stand (not included) with larger work pieces.
Never stand on the Tile Saw. Serious injury could result if the Tile Saw is tipped
or if the rotating Saw Blade is accidently contacted.
Industrial applications must follow OSHA requirements.
For your safety: In extreme working conditions, sensors in the Tile Saw will
automatically switch off the Motor to prevent overheating. In this event, turn
the Power Switch to its “OFF” position. Wait five minutes or until the Motor has
cooled. Making sure your hands are dry, depress the Circuit Breaker. Then, turn
the Power Switch to its “ON” position to resume cutting. NEVER attempt to dis-
able the Circuit Breaker.
Never attempt to cut more than one tile at a time.
Never attempt to cut freehand. Make sure the tile to be cut is pressed firmly
against the Rip Fence.
Never cut pieces too small to be held securely against the Rip Fence with-
out leaving enough space for the hand to be a safe distance from the Saw
Blade.
Make sure the tile to be cut off has sufficient room to move sideways. Failure
to do so may result in the tile binding against the Saw Blade.
Make sure the Table and surrounding area are clear with the exception of the
tile to be cut.
Always turn off the Tile Saw and unplug it from its electrical outlet before
changing accessories or performing any inspection, maintenance, or clean-
ing procedures.
22.
23.
24.
25.
26.
27.
28.
29.
30.
31.
32.
33.
34.
35.
36.