Filter
Top Products
SKU 92917 & 93253 For technical questions, please call 1-800-444-3353. Page 3
it was intended. Do not modify this tool and do not use this tool for a purpose for
which it was not intended.
Dress properly. Do not wear loose clothing or jewelry as they can be caught in
moving parts. Protective, electrically nonconductive clothes and nonskid foot
wear are recommended when working. Wear restrictive hair covering to contain
long hair.
Do not overreach. Keep proper footing and balance at all times. Do not reach
over or across running machines or air hoses.
Use eye and ear protection. Always wear ANSI-approved impact
safety goggles and appropriate hearing protection. Wear a full face shield
if you are producing metal filings or wood chips. Wear a NIOSH-approved
dust mask or respirator when working around metal, wood, and chemi-
cal dusts and mists. Other people in the work area must also wear ANSI-approved
impact safety goggles.
Maintain tools with care. Keep tools clean for better and safer performance. Fol-
low instructions for lubricating and changing accessories. Inspect tool cords and
air hoses periodically and, if damaged, have them repaired by a qualified techni-
cian. The handle must be kept clean, dry, and free from oil and grease at all times.
Do not operate a tool if any portion of the tool’s operating controls are inoperable,
disconnected, altered or not working properly.
Disconnect Air Hose and release any built-up air pressure. Never service the
Nailer, clear jams, or disassemble with the air hose attached. Always release any
built-up air even after disconnecting hose. Disconnect the Nailer when not in use.
Remove adjusting keys and wrenches. Check that keys and adjusting wrenches
are removed from the tool or machine work surface before attaching to an air
source.
Avoid unintentional starting. Be sure the trigger is in the Off position when not
in use and before plugging in. Do not carry any tool with your finger on the trigger,
whether it is attached to an air source or not. Do not point the tool towards yourself
or anyone whether it contains fasteners or not.
Stay alert. Watch what you are doing, use common sense. Do not operate any
tool when you are tired.
Check for damaged parts. Before using any tool, any part that appears damaged
should be carefully checked to determine that it will operate properly and perform
its intended function. Check for alignment and binding of moving parts; any broken
parts or mounting fixtures; and any other condition that may affect proper operation.
Any part that is damaged should be properly repaired or replaced by a qualified
technician. Do not use the tool if the trigger does not operate properly.
6.
7.
8.
9.
10.
11.
12.
13.
14.