Filter
Top Products
FIGURE D
SYMBOLOGY
Double Insulated
Canadian Standards
Association
Underwriters
Laboratories, Inc.
Volts Alternating Current
Amperes
No Load Revolutions
per Minute (RPM)
n
o
xxxx/min.
A
V ~
UNPACKING
When unpacking, check to make sure all the parts shown on the Parts List on page 14
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
ASSEMBLY INSTRUCTIONS
1. WARNING! Make sure the Power Switch (7) of the Grinder is in its
“OFF” position and its Power Cord/Plug (13) is unplugged from the
electrical outlet prior to performing any assembly.
To Attach The Right Moveable Tool Rest:
1. The
left
Moveable Tool Rest (5) has been pre-attached by the manufacturer.
However, the
right
Moveable Tool Rest (5) must be attached by the operator prior
to using the Grinder. (See Figure E, next page.)
2. To attach the right Moveable Tool Rest (5), insert its mounting slot onto the
protruding, threaded, Bolt located on the front of the Grinder. Then, secure the
Moveable Tool Rest, using the Wing Nut (6). IMPORTANT: Make sure to adjust
the distance between the Moveable Tool Rest and Grinding Wheel (40)
to a 1/16” or less separation. (See Figure E.)
SKU 94071 For technical questions, please call 1-800-444-3353 PAGE 10