Filter
Top Products
SKU 94071 For technical questions, please call 1-800-444-3353 PAGE 11
To Attach The Spark Shields:
1. A Spark Shield (20) must be attached to both the Left
Safety Guard Plate (17) and Right Safety Guard Plate
(32).
2. To do so, for each Spark Shield use two Philips Screws
(18), two Flat Washers (19), two Spring Washers (22),
and two Hex Nuts (21). Be sure to orient it as shown in
the illustration to the right. (See also Figure E, below.)
To Mount The Grinder On A Workbench:
1. CAUTION! Make sure the workbench on which the Grinder will be mounted
is flat, level, and sturdy enough to support the weight of the Grinder, any work-
pieces, and any additional tools.
2. The Grinder is equipped with four Rubber Feet (3) which allows the tool to be
temporarily placed upon a workbench for use. However, if the Grinder is to be
permanently mounted on a workbench, the Rubber Feet must be removed.
(See Assy. Diagram.)
3. To permanently mount the Grinder on a workbench, remove the Rubber Feet (3)
and place the Grinder in the desired work location on the workbench. Use the
four mounting holes at the Base (4) as a template to mark the areas where four
3/16” diameter mounting holes should be drilled through the workbench.
4. Temporarily remove the Grinder, and drill the four 3/16” diameter mounting holes
LEFT
SAFETY
GUARD PLATE
(17)
RIGHT
SAFETY
GUARD PLATE
(32)
PHILIPS SCREW
(18)
FLAT WASHER
(19)
SPARK SHIELD
(20)
SPRING WASHER
(22)
HEX NUT
(21)
MOVEABLE TOOL REST
(5)
WING NUT
(6)
ONOFF
FIGURE E
REV 03/06