Filter
Top Products
SKU 95082 For technical questions, please call 1-800-444-3353. Page 13
1. Unscrew and remove the Bolts (16)
on the Blade Guard (14), slide Blade
Guard slightly to the right, and lift it.
See Figure D.
Figure D
2. Using gloves, rotate the Cutterhead
(53) so that the Screws (55) are
accessible.
3. Using the Hex Wrench (122),
unscrew and remove the six Screws
(55) securing the Gib (56). See
Figure D. Place the Screws in a safe
location.
4. Using the two tool Magnets (123), lift
the Gib off and set aside.
5. Using the two Magnets (123), lift the
Blade (57) off the Cutterhead (53).
See Figure E.
Note: Leave Springs (58) in place.
Figure E
6. Since the Blade has a double-edge,
rotate the Blade using Magnets
(123). WARNING! Do not attempt to
sharpen blades, only replace them.
Use the pins located on each side to
position the Blade in place.
7. Replace the Gib over the Blade and
secure with the six Screws.
Securely tighten Screws using the
Hex Wrench (122).
Blades require no adjustment and
automatically locks into place.
8. Using gloves, rotate the Cutterhead
(53) so that the second Blade is
accessible.
9. Repeat steps 2 through 8 on the
second Blade.
10. Replace the Blade Guard (14) and
secure with Bolts (16). Securely
tighten Bolts.
Blade Guard (14)
Gib (56)
Magnets (123)
Magnets (123)
Cutterhead (53)
Blade (57)
Gib (56)