Filter
Top Products
SKU 95082 For technical questions, please call 1-800-444-3353. Page 9
Place Rubber Cap (5) on the Handle 5.
and tighten Bolt (6) into the Right Cap
(11).
Using a screwdriver (not included), 6.
fasten the two Cord Wrap Frames
(29) to the Side Cover (30) using four
Screws (28). See Figure B.
Use included Hex Wrench (122) to 7.
loosen Head Screw (79) on the frame
of the Dust Chute (80). Slide Dust
Chute over Fan Housing (78). Fas-
ten Dust Chute in place by tightening
Head Screw. See Figure C.
Mount a trash bag (not included) to 8.
the Dust Chute (80) to collect the
dust.
WARNING! 9. Make sure Blade is fas-
tened and tightened down securely
before beginning any work. Refer to
“Changing Cutting Blades” section
of this manual to tighten blade prop-
erly).
OPERATING INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
Tool Set Up
TO PREVENT
SERIOUS INJURY
FROM ACCIDENTAL
OPERATION:
Turn the Power Switch of the
tool to its “OFF” position and
unplug the tool from its
electrical outlet before
performing any inspection,
maintenance, or cleaning
procedures.
Work Piece and Work Area Set Up
Designate a work area that is clean 1.
and well-lit. The work area must not
allow access by children or pets to
prevent injury and distraction.
Route the power cord extension 2.
along a safe path to reach the Planer
without creating a tripping hazard or
exposing the power cord to possible
damage.
There must not be hazardous ob-3.
jects, such as utility lines or foreign
Figure B
Side
Cover (30)
Cord Wrap
Frames (29)
Screws
(28)
Figure C
Hex Wrench
(122)
Head Screw
(79)
Fan Housing
(78)
Dust Chute (80)
Rev 10d