Filter
Top Products
SKU 95386 For technical questions, please call 1-800-444-3353. Page 10
OPERATING INSTRUCTIONS
NOTE: For additional information regarding the parts mentioned in the following pages,
refer to the Assembly Diagrams on page 16.
1. IMPORTANT! Always fill the Air Compressor with a premium quality,
30-weight, non-detergent, compressor oil before each use. Running the Air
Compressor with no oil or low oil will cause damage to the equipment and
void the warranty. To check the level of oil, make sure the Air Compressor is
OFF. Then, observe the Oil Sight Gauge (33). The level of oil should be within
the red circle on the Oil Sight Gauge (33). (See Figure D, next page) If the level of
oil is below the red circle, carefully unscrew and remove the Oil Plug (31) and
UNPACKING
When unpacking, check to make sure all the parts shown on the Parts Lists on page 15
are included. If any parts are missing or broken, please call Harbor Freight Tools at the
number shown on the cover of this manual as soon as possible.
23. WARNING! The warnings, precautions, and instructions discussed in this
manual cannot cover all possible conditions and situations that may occur. The
operator must understand that common sense and caution are factors which
cannot be built into this product, but must be supplied by the operator.
24. WARNING! The brass components of this product contain lead, a chemical
known to the State of California to cause birth defects (or other reproductive
harm). (California Health & Safety code § 25249.5,
et seq.
)
FIGURE C
WATER
OILER
TO
AIR TOOL
TO:
AIR OUTLET
VALVE (63)