Filter
Top Products
install the convex (rounded outward) side of the Grinding Wheel toward the
Spindle (7). (See Figure E.)
3. Screw the Outer Flange Nut (1) onto the Spindle (7). Depress and hold the Lock
Pin (22) to keep the Spindle from turning. Then, use the provided Wrench (51)
to firmly tighten the Outer Flange Nut onto the Spindle. (See Figure E.)
SKU 95578 For technical questions, please call 1-800-444-3353 PAGE 11
FIGURE E
A
B
C
To Attach The Side Handle:
1. The Side Handle (18) may be attached to either the
left
or
right
side of the Angle
Grinder. (See Figure F.)
2. To attach the Side Handle (18) to the Angle Grinder, screw the Handle firmly into
the threaded mounting hole located on either the left or right side of the Shell
Head (23). (See Figure F.)
GRINDING
WHEEL
SPINDLE
(7)
OUTER
FLANGE
NUT
(1)
OUTER
FLANGE
NUT
(1)
WRENCH
(51)
LOCK PIN
(22)
FIGURE F
SIDE
HANDLE
(18)
SHELL
HEAD
(23)
OPERATING INSTRUCTIONS
1. WARNING! Make sure the Power Switch (41) of the Angle Grinder is in its
“OFF” position before connecting the Power Cord/Plug (50) to a 120 volt,
grounded, electrical outlet.