Harbor Freight Tools 96300 Cordless Drill User Manual


  Open as PDF
of 7
 
Page 5SKU 96300
For technical questions, please call 1-800-444-3353.
Secure Planishing Hammer to the Planishing Hammer Stand by sliding a grade-5
bolt (not included) of adequate length through a flat washer (not included), then
through the base hole of the Planishing Hammer, and then through the mounting
plate of the Stand. Slide another flat washer (not included) over the bolt. Attach a
self-locking nut (not included). Repeat this operation for the remaining mounting
holes. Then tighten all the nuts.
The Planishing Hammer Stand has three 7/16” holes for mounting the Stand to your
work surface (hardware not included). Use on a flat, level surface capable of
supporting the Planishing Hammer Stand, the Planishing Hammer, the metal
being worked on, and the vibration of the planishing process.
INSPECTION, MAINTENANCE, AND CLEANING
Clean the Planishing Hammer Stand with a damp cloth. Do not use abrasives,
harsh chemicals or detergents as these will scratch and damage the Planishing
Hammer Stand.
BEFORE EACH USE, inspect the general condition of the Planishing Hammer
Stand. Check for loose fasteners, cracked or broken parts and any other condition
that may affect its safe operation. Always make sure the Planer is firmly attached
to the Stand. Do not use damaged equipment.
PARTS LIST
Part Description Q’ty
1 Leg 1
2 Table Support 1
3 Main Support 1
4 Bolt M 8 x 50mm 2
5 Bolt M8 x 75mm 2
6 Bolt M8 x 20mm 2
Part Description Q’ty
7 Nut M8 4
8 Cross Bar 1
9 Spring Washer 6
10 Flat Washer 10
11 Plug 2
PLEASE READ THE FOLLOWING CAREFULLY
THE MANUFACTURER AND/OR DISTRIBUTOR HAS PROVIDED THE PARTS LIST AND ASSEMBLY DIAGRAM IN THIS
MANUAL AS A REFERENCE TOOL ONLY. NEITHER THE MANUFACTURER OR DISTRIBUTOR MAKES ANY REPRESEN-
TATION OR WARRANTY OF ANY KIND TO THE BUYER THAT HE OR SHE IS QUALIFIED TO MAKE ANY REPAIRS TO THE
PRODUCT, OR THAT HE OR SHE IS QUALIFIED TO REPLACE ANY PARTS OF THE PRODUCT. IN FACT, THE MANU-
FACTURER AND/OR DISTRIBUTOR EXPRESSLY STATES THAT ALL REPAIRS AND PARTS REPLACEMENTS SHOULD BE
UNDERTAKEN BY CERTIFIED AND LICENSED TECHNICIANS, AND NOT BY THE BUYER. THE BUYER ASSUMES ALL
RISK AND LIABILITY ARISING OUT OF HIS OR HER REPAIRS TO THE ORIGINAL PRODUCT OR REPLACEMENT PARTS
THERETO, OR ARISING OUT OF HIS OR HER INSTALLATION OF REPLACEMENT PARTS THERETO.
8.
9.
1.
2.
 previous next